Zinc & Epoxy Coatings Print E-mail

Once a job has been blasted clean then comes the next stage, Protection.

We can supply and apply all types of Epoxy’s and Wet Zinc Coatings. Our trained spray painters are qualified to apply paint to the manufacturer's specifications and film thickness.

 

 

Quality Finish Guaranteed

Paint is measured wet by a calibrated thickness gauge and a wet film measurement is taken, which then determines the dry film thickness measured in microns. The paint is measured dry with a digital electronic gauge. A typical accepted paint measurement would read as Zinc 50-75um, Primer 75um. Topcoat 50um total film thickness 175um -200um.

 01a

 


Common Misconceptions

You will often here painter’s saying I sprayed on ten coats of clear!! Ok sounds great, but at what thickness is a coat?

Typically this means they may not be using the required amount of paint that the manufacture requires for their product to work effectively, therefore your job will begin rusting prematurely and will require repainting. At Chemblast, you can be assured that your job will be completed with the attention to detail that will maximise your project or products life.
 

 

450m2 paint room with
low-bake oven